Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Window Installation Across Redwood Shores
Window installation in Redwood Shores runs between $850 and $2,400 per window for most homes here, depending on frame material, glass package, and whether your HOA requires specific finishes. Most single-window replacements take one day once the architectural review clears. If you’re calling about a fogged dual-pane or a sliding door that binds, call (888) 635-0804 and a live person will answer, not a voicemail tree.
We’ve worked the lagoon streets and the interior courts of Redwood Shores long enough to know the houses here share a build era, a salt-air problem, and an HOA process. That local knowledge means we schedule around the approval calendar, not against it. Crews serving Redwood Shores are dispatched from our San Francisco Bay Area office, and we carry the frame finishes and hardware that the architectural boards in this master-planned community actually sign off on.
Why TruePane Windows & Doors Is Redwood Shores’s Preferred Window Installation Company
Dale Kessler founded TruePane in 2008 on a rule that still sits on the whiteboard: if the pane is not true, the job is not done. That rule carries through every window installation we do in Redwood Shores, from a single casement swap on a condo near the lagoon to a full-house retrofit on a 1990s stucco two-story.
We’re not the cheapest bid in the room. We’re the last call most homeowners need to make. The Keystone Standard backs every job: both manufacturer warranty layers registered in writing, durations stated, before the truck leaves the driveway. Then the Done Right Promise covers the workmanship. If something is not right, we make it right. No paperwork fights. No arguing. That’s the whole promise.
Background-checked, uniformed technicians measure every opening twice and quote manufacturer lines side by side on paper, so you see exactly what you’re buying before you sign. We’re an authorized installer for more than a dozen lines, including. And when you call, a live person answers. Twenty-four hours a day, seven days a week. That matters to homeowners in Redwood Shores who remember the contractor who never called back.
Our Window Installation Services in Redwood Shores
Most homes in Redwood Shores were built between roughly 1983 and 1998, and the original aluminum frames are now past service life. Here’s what we install most often, and how it applies to houses on the reclaimed bay edge.
Sliding Windows
Sliding windows are the workhorse of Redwood Shores homes, especially on lagoon-facing streets where horizontal sightlines matter and wind loads off the bay run steady. We install Milgard and Andersen sliders with fusion-welded frames and marine-grade stainless hardware as standard practice on waterfront lots. The track and roller assembly gets just as much attention as the glass. In the Lagoon neighborhood and along the Foster City border, we replace slider units where zinc-plated hardware has pitted within a season or two.
Fixed & Picture Windows
Fixed and picture windows are common on Redwood Shores homes where the lagoon view is the point of the room. These are also the units most often fogged, because the original dual-pane seals have been fighting bay humidity for three decades. Replacing a picture window here is not just a glass swap. The stucco return, flashing, and any dry-rot at the sill need to be addressed or the new unit will fail the same way. We rebuild the opening, not just the pane.
Bow & Bay Windows
Bow and bay windows are a popular project in Redwood Shores for the homes on wider courts, where a projecting window adds a sitting ledge and a better angle on the water. These installations require structural considerations: weight distribution on the cantilever, house wrap, and a roofline that meets HOA approval. We file the architectural review packet ourselves with color chips, cross-section drawings, and wind-load calcs, so the project is not sitting half-finished waiting on a committee.
Casement Windows
Casement windows seal tighter than any other operable style, which matters when the marine layer rolls through Redwood Shores evenings from spring into fall. The crank hardware on 30-year-old casements is usually the first thing to seize from salt exposure. When we install new casements here, we recommend stainless or anodized hardware finishes and a low-E glass package rated for coastal exposure.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Redwood Shores
We’re an authorized installer for more than a dozen manufacturer lines. For Redwood Shores specifically, we work heavily with Milgard, Andersen, PGT, and Marvin. Milgard’s fusion-welded vinyl holds up well against persistent bay moisture. PGT and CGI offer impact-rated glazing for homeowners who want the added storm and debris protection. Andersen and Marvin give the architectural flexibility that many Redwood Shores HOAs look for when reviewing frame color and finish. We keep common track hardware, rollers, and balance assemblies in local stock, and we quote manufacturer lines side by side on paper so you can compare the actual numbers yourself.
Common Window Installation Problems We See in Redwood Shores Homes
- HOA non-compliance before approval. A homeowner installs a window with a non-approved frame color or finish before architectural review is complete, and the board requires removal and reinstallation at the owner’s expense. We’ve seen this happen on both the lagoon and interior courts. It’s the single most expensive mistake on any Redwood Shores window project, and it’s entirely avoidable.
- Zinc-plated hardware on waterfront lots. Standard zinc-plated track hardware on a lagoon-fronting home pits within one salt-air season. Marine-grade anodized or stainless is the spec, not an upgrade. On homes within a few hundred feet of open water or the bay trail, corrosion cycles run noticeably faster than blocks closer to Redwood Shores Parkway.
- Fogged sealed units with corroded aluminum jambs. Many original aluminum frames have internal corrosion that is not visible until the glass comes out. Replacing only the insulated glass unit without rebuilding the jamb and sash leaves the new unit unsupported, and the seal fails again. In Redwood Shores, where the build era is uniform, this is a block-by-block pattern.
- Sliding door tracks that bow and derail. On lagoon-facing homes, the original aluminum sliding glass door tracks corrode and bow to the point where the panel jumps the rail. This is a track and frame replacement job, not a glass job. We spec fusion-welded frames and anodized stainless on these to hold up in salt, moisture, and morning marine layer.
Pricing for Window Installation in Redwood Shores, CA
A typical window installation in Redwood Shores runs $850 to $2,400 per opening. Casement windows in standard sizes run $900 to $1,800 installed. Sliding windows run $1,000 to $2,200 depending on width and glass package. Fixed and picture windows run $850 to $1,900 for common sizes. Bow and bay windows run $3,500 to $7,000 because they involve structural support, roof work, and finish carpentry.
What moves the number in Redwood Shores specifically: whether you’re on a lagoon front requiring marine-grade hardware, whether impact-rated glazing is required, whether the HOA requires a specific frame color or finish that must be special-ordered, and whether the existing opening has hidden corrosion or dry-rot behind the old frame. We give you a written line-item quote before work starts. The number on the quote is the number on the bill. No change orders, no surprise line items. Call (888) 635-0804 for a free estimate.
We Also Serve Cities Near Redwood Shores
Our crews serve Redwood Shores and the surrounding communities along the bay. We work in Parkway, Arden-Arcade, Ladera Heights, and Commerce as well. If you’re just outside the Redwood Shores city line, call and we’ll confirm coverage. For more detail on the full scope of our work, see our Window Installation in Redwood Shores page or the main service overview.
Serving Redwood Shores, CA - Our Local Coverage Area
We’re based in the Redwood Shores area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Window Installation in Redwood Shores
Most Redwood Shores HOA architectural reviews add two to five weeks to the calendar, depending on the board’s meeting schedule and whether your submittal is complete the first time. The review is not a code inspection; it is a covenant check on frame color, finish, style, and exterior appearance. We file the packet ourselves with color chips, cross-section drawings, and wind-load calcs, which clears the most common reason for delay: an incomplete application. Call (888) 635-0804 with your project details and we’ll walk you through the timeline.
White, tan or beige, and bronze or dark bronze are the colors most consistently approved across Redwood Shores covenants. These match the stucco and trim palette of the original 1980s and 1990s build-out. Black frames have been approved on some newer custom homes, but the board will want to see a color chip against your stucco sample first. We carry physical samples for the most common Milgard, Andersen, and Marvin finishes and will file whichever the board requires. For an exact fit to your covenant, call (888) 635-0804 and we’ll pull the colors that have passed recently in your neighborhood.
It depends on your specific HOA’s governing documents, but the safest answer in Redwood Shores is yes, you file. Some boards waive review for like-for-like replacements. Others want the submittal anyway and will fine you retroactively if they find the work was done without notice. The cost of filing is small compared to a notice of violation and a remediation order. We handle the submittal packet either way, and we schedule the installation to start after the approval lands. Call (888) 635-0804 and we’ll check the written rules for your specific association.
Yes, impact-rated glazing usually passes architectural review as long as the frame color, finish, and profile match what the HOA allows. The glass itself is not the issue in Redwood Shores; the frame appearance is. PGT and CGI make impact-rated units with frame options that align with standard Redwood Shores color palettes. We file the spec sheet and a visual sample together so the board sees the exterior look before they see the impact rating. For a quote on impact-rated glazing, call (888) 635-0804.
Usually not. When the aluminum track has bowed on a Redwood Shores lagoon-fronting home, the frame is corroded through, not just the track. Replacing the track alone leaves the frame as the failure point, and the new hardware will bind within months. The proper fix is a full frame and track replacement, often with a fusion-welded Milgard or Andersen unit and anodized stainless hardware. We’ve done exactly this on lagoon-facing homes in the Lagoon neighborhood, and the fix holds because the material spec matches the environment. Call (888) 635-0804 and we’ll come measure the bow and give you a straight answer.
When you’re ready to price the work, call (888) 635-0804 for a free estimate. A live person answers. We’ll schedule a measure, file the HOA packet if needed, and get your windows done right the first visit.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Redwood Shores and the surrounding Bay Area since 2008.