Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Door Installation Across Campbell
A new entry door in Campbell typically runs $1,800 to $4,600 installed, and a full retrofit that touches framing and fire-rating requirements on the west side lands between $3,800 and $9,500. The spread is wide because Campbell’s housing stock doesn’t hand you a standard opening every time. We’re a second-generation glazier’s shop that has worked these streets long enough to know what’s behind the siding on a 1960s ranch off Winchester, and we price for what’s actually there, not what a catalog assumes. If you’re planning a door replacement anywhere in Campbell, call (888) 635-0804 and we’ll walk the opening with you before any number gets written down.
Why TruePane Windows & Doors Is Campbell’s Preferred Door Installation Company
Dale Kessler founded this company in 2008 on a rule that still governs every job we take: if the pane is not true, the job is not done. That’s not a slogan. It’s the standard our technicians carry into every Campbell home, and it’s why we register both manufacturer warranty layers in writing before the truck leaves your driveway. We’ve worked in Campbell long enough to know the difference between a Westmont rancher and a pre-war bungalow near the Pruneyard, and neither one surprises us anymore.
Campbell homeowners call us because a live person answers, every time. No voicemail tree, no callback form. When a door binds in summer or a jamb starts showing rot from fog-driven moisture, you want someone who picks up the phone and knows what a 95008 address means for permit requirements. Our background-checked, uniformed crews serve Campbell from our Bay Area scheduling office, and we show up when we say we will.
The work is covered by our Done Right Promise. If something isn’t right, we make it right, no paperwork fights. That’s the Keystone Standard, and it’s why homeowners who’ve been burned once by a cheap door install tend to stay with us for the next project.
Our Door Installation Services in Campbell
Entry & Swing Doors
The front door on a 1950s Campbell ranch often sits in a rough opening that was framed for a single-pane aluminum unit, not a modern pre-hung fiberglass or steel door. We measure every opening twice, quote the manufacturer line on paper next to its competitor, and rebuild the jamb when the framing doesn’t meet code for the new unit. A straightforward swing-door replacement in a standard opening usually runs $1,800 to $3,600 in Campbell. If the opening needs reframing, we put that number in writing before we touch a saw.
Double & French Doors
Double doors and French doors on Campbell homes carry a heavier weather load on the west and north exposures, where marine air funnels in from the Santa Cruz Mountains and cycles condensation across the threshold. We set these units with full flashing tape, sill pans, and a level that gets checked twice, because a French door that sags even an eighth inch will bind at the top by the first winter. Pricing for a paired door install in Campbell typically starts around $2,800 and runs upward with glass options and hardware.
Bifold & Folding Doors
Campbell’s ranch homes don’t always have the header span for a wide folding door without structural work. We inspect the lintel and the load path before quoting, then handle the permit and the engineering so the install doesn’t become a stop-work headache. Bifold and folding door work in Campbell is a custom job most of the time, with pricing that reflects the header work and track hardware, usually $4,200 to $9,000 depending on panel count and glass package.
Pivot Doors
Pivot doors are a statement piece, and some of the newer higher-end builds along the Los Gatos border have the ceiling height to carry one. We set pivot hardware with a machinist’s level, shim the pivot box to the floor structure, and verify the swing clearance before the slab goes in. A pivot door install in Campbell is rarely under $4,000, and the hardware alone can push it higher. We quote the full assembly, including the pivot box and floor reinforcement, not just the door slab.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Campbell
We hold authorized installer status with more than a dozen manufacturer lines, and in Campbell we work most often with units because they hold up under the condensation cycling we see on the west side. For fire-zone work near the foothills, we specify CGI and ES Windows products when the permit calls for impact-rated or ember-resistant glazing. We keep common hardware, weatherstripping, and threshold parts in local stock so a service follow-up on a Campbell door doesn’t wait on a freight truck from the Midwest.
Common Door Installation Problems We See in Campbell Homes
- Non-standard rough openings from the 1950s through 1970s. Original aluminum slider frames were built to dimensions that don’t match modern code-compliant pre-hung doors. A direct swap without reframing leaves air leaks and seal failure within two seasons.
- Concealed wood rot on west- and north-facing jambs. Fog and marine air condense on the hinge side of older Campbell doors, and the rot hides behind the casing until the unit comes out. Installing a new door over a rotten jamb without a tear-out causes the frame to sag and the sash to bind within a year.
- Fire Hazard Severity Zone surprises on the west side. Homes near the Los Gatos border sit inside California-designated FHSZ boundaries. Replacing a door there without checking the fire zone map can trigger a stop-work order and a forced upgrade to dual-pane tempered glass and ember-resistant frames after the old unit is already out.
- Failed flashing tape on original aluminum doors. The tape used in the 1960s and 70s dries out and loses adhesion. Once water gets behind it, the jamb rots from the inside. We always replace the full flashing assembly, not just the tape you can see.
Pricing for Door Installation in Campbell, CA
A standard entry door replacement in Campbell runs $1,800 to $3,600 for a pre-hung unit in a code-compliant opening. Double or French doors start around $2,800 and reach $6,500 with custom glass and hardware. Bifold and folding doors range $4,200 to $9,000. Pivot doors start around $4,000 and climb with hardware and structural work. If your home sits in the west-side Fire Hazard Severity Zone, add $800 to $2,400 for ember-resistant framing and dual-pane tempered glazing that a flatland city like Santa Clara wouldn’t require. Every Campbell quote includes the inspection findings, the permit fees, and the change-order protocol in writing, so nothing shows up on the bill unannounced. Call (888) 635-0804 for a free estimate, and we’ll come out and look at the actual opening.
We Also Serve Cities Near Campbell
Our Door Installation team works regularly in Saratoga, Los Gatos, Cupertino, and Santa Clara. The fire-zone requirements and framing habits shift block by block across the valley, and we know which rules apply where. If you’re in one of those neighboring cities, the same inspection-first pricing applies, and we’ll quote Door Installation in Campbell or your own home with the same standard. Call (888) 635-0804 and we’ll set a time.
Serving Campbell, CA - Our Local Coverage Area
We’re based in the Campbell area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Door Installation in Campbell
If your home sits on Campbell’s west side near the Los Gatos border, probably yes. The state’s Wildland-Urban Interface map puts portions of that area inside a Fire Hazard Severity Zone, and a building permit for a door replacement triggers a compliance review. That means ember-resistant frames and dual-pane tempered glass, which are not required in flatland cities like Cupertino or Santa Clara proper. We check the zone map before quoting so the review doesn’t surprise you mid-project. Call (888) 635-0804 with your address and we’ll tell you what applies.
Because the original aluminum slider frames from that era were set into openings that are frequently 1 to 2 inches narrower than what a modern code-compliant pre-hung door needs. Sliding a same-size unit into that hole leaves air leaks, seal failure, and a door that fights you every season. We rebuild the opening to the correct dimensions, which is reframing work, and that’s priced into the quote before we start. For an exact number on your home, call (888) 635-0804 and we’ll measure.
Yes, and it’s more common here than further east in the valley. Campbell’s position at the base of the Santa Cruz Mountain foothills lets marine fog and night air cycle across west- and north-facing door glass, and once the seal fails, the condensation isn’t going to dry out and fix itself. The glazing is compromised and the unit needs replacement, not repair. We’ll walk you through the glass options in your price range when you call (888) 635-0804.
Yes. Campbell’s architectural compatibility guidelines add a review step for pre-war bungalows in the older pockets around Downtown Campbell, and the replacement door has to match the historic character of the street. We prepare the drawings and the permit package, and we’ve shepherded enough of these through the review to know what the city will push back on. It adds time, not uncertainty. Call (888) 635-0804 and we’ll tell you what your specific block requires.
We charge inspection-first. Once the old unit comes out and we can see the jamb, the sill, and the studs behind the flashing, we price any rot repair or reframing in writing before we cut further. That’s the change-order protocol, and it’s the same one that prevented a surprise on a 1960s ranch near the Los Gatos border where the original flashing tape had failed and the rough opening was undersized by an inch and a half. Nothing gets tacked onto the bill without your signature. Call (888) 635-0804 to schedule the tear-out and inspection, and the estimate is free.
Written by Dale Kessler, Owner at TruePane Windows & Doors.